Six Sigma Settings

Six Sigma is a set of practices to systematically improve processes by reducing process variation and thereby eliminating defects. For a more detailed explanation of Six Sigma, see the @RISK and SixSigma Guide under the Guides section.

Figure 1 - Six Sigma Settings

Six Sigma settings are turned off by default, and cannot be set for the entire Simulation - they must be set for each Output individually. If the selected Output should use the Six Sigma methodology, those settings are configured in the Six Sigma tab of the Add Output (Advanced) window (Figure 1, right).

When a distribution is configured to useSix Sigma, the @RISK property function RiskSixSigma is added to the function as an optional argument.

Check the 'Calculate Capability Metrics for this Output' box to turn on capability metrics in reports and graphs for the selected Output. The metrics will use the Lower Specification Limit (LSL), Upper Specification Limit (USL) and Target values specified in the Specification Limits section.

Specification Limits

Specification limits provide the target value for the Output distribution, as well as the Lower and Upper limits for the distribution values. Specification Limits are derived from the process requirements, and specify the minimum and maximum acceptable limits of the process. The Lower and Upper limits each fall within 3 Standard Deviations of the mean, for a total of six Standard Deviations.

LSL (Lower Specification Limit) - The value three standard deviations below the Mean, or Target, of the Output.
USL (Upper Specification Limit) - The value three standard deviations above the Mean, or Target, of the Output.
Target - The Target, or Mean, outcome of the distribution.

Other

Use Long-Term Shift - Check this box to enable Long-Term Shift for the Output; see Six Sigma for more information.
Shift - The specific value to use for Shift.
Upper/Lower X Bound - The number of standard deviations to the right or the left of the mean for calculating the upper and lower x-values.